FabFilter User Forum

Pro-Q3 - Fine Tuning on Output Pan?

Does anybody know if it is possible to apply fine tuning to the output pan when using mac? The usual method doesn't seem to work for me.

I hold shift and move the dial but it just moves really quickly. I find this awkward because I like to put the signal into mono, work on the mono mix and then gradually fade the stereo signal back in. This is hard on the Pro-Q3 because I can't seem to apply the fine tuning.

I know I can do this in other ways in the DAW but want to do it inside the Pro-Q3...any ideas?

Ricky Evans — Nov 28, 2020

Hi Ricky,

That's strange, I just tested it and can use fine-tuning here without any problem. Make sure you click and drag the side of the dial, not the "arrow": that will enable rotational drag mode and won't allow fine-tuning. Or press Shift before clicking.

Cheers,

Frederik (FabFilter) — Nov 30, 2020

Thanks so much. I was clicking on the arrow and therefore unable to apply the fine-tuning. It works if i just click and drag the outer ring. :)

Ricky Evans — Dec 1, 2020

Reply to this topic Go to the forum topic list