FabFilter

Does anybody know if it is possible to apply fine tuning to the output pan when using mac? The usual method doesn't seem to work for me.

I hold shift and move the dial but it just moves really quickly. I find this awkward because I like to put the signal into mono, work on the mono mix and then gradually fade the stereo signal back in. This is hard on the Pro-Q3 because I can't seem to apply the fine tuning.

I know I can do this in other ways in the DAW but want to do it inside the Pro-Q3...any ideas?

Hi Ricky,

That's strange, I just tested it and can use fine-tuning here without any problem. Make sure you click and drag the side of the dial, not the "arrow": that will enable rotational drag mode and won't allow fine-tuning. Or press Shift before clicking.

Cheers,

Thanks so much. I was clicking on the arrow and therefore unable to apply the fine-tuning. It works if i just click and drag the outer ring. :)