FabFilter

When adding a LOW CUT or HIGH CUT, the Q defaults to a value other than 1 (I observed: 0.962, 1.006, 0.984, 1.028 etc.)

When adding a BELL the Q defaults to 1, as normal.

v1.23, Logic X

Cheers,
L.

Hi Leigh,

If you create a new low/high-cut filter by double-clicking at the left and right edges of the display, the vertical position where you click determines the Q setting. You can easily reset to 1 by Ctrl-clicking (Cmd-click on Mac) the Q knob.

Cheers,

Hi Frederik,

I see - just checked and you're right (as usual) is this behaviour new?

Cheers,
L.

Hi Leigh,

It's always been this way. However we'll think about changing it as it's not very intuitive actually...

Cheers,

Weird. I never noticed it before.

Never mind. Hope you guys are enjoying the summer!